Login
My Garage

Jaguar F-TYPE Recalls

There are currently 16 safety recalls out on the Jaguar F-TYPE. To find out whether your car is affected, you'll need to find your car's VIN number.

How to find your VIN

The VIN can often be found on the lower-left corner of the dashboard, in front of the steering wheel.

You can read the number by looking through the windshield. The VIN may also appear in a number of other locations:

  • Front of the engine block. This should be easy to spot by opening the bonnet, and looking at the front of the engine.
  • Front of the car frame, near the container that holds windshield washer fluid.
  • Rear wheel well. Try looking up, directly above the tyre.
  • Inside the driver-side doorjamb. Open the door, and look underneath where the side-view mirror would be located if the door was shut.
  • Driver-side doorpost. Open the door, and look near the spot where the door latches, not too far from the seatbelt return.
  • Underneath the spare tyre.
VIN Location Diagram

If you still can't locate the VIN, try consulting your vehicle manual. Or, call a dealership or the manufacturer and request guidance.

Step 2 - See if your car is affected
  • Announcement date:
    19/08/2022
    Recalls number:
    R/2022/223
    VIN start:
    SAJDA1AE4NCK79393
    VIN end:
    SAJDB1AE2NCK78742
    Car Build Date:
    13/01/2022 - 15/03/2022
    Concern:
    A Damaged Front Seat Belt Pre Tensioner Tube May Have Been Installed On The Seat Belt Retractor
    Defect:
    Damaged front seat belt pretensioner tube may have been installed on the seat belt retractor.
    Remedy:
    Inspect the seat belt pretensioner tube for damage and if damage is identified the seat belt retractor will be replaced.

  • Announcement date:
    16/07/2021
    Recalls number:
    R/2021/248
    VIN start:
    SAJDA1AV4KCK60287
    VIN end:
    SAJDB1AXXKCK61636
    Car Build Date:
    27/07/2018 - 27/09/2018
    Concern:
    The Passenger Airbag Deployment Door Integrated In The Instrument Panel Facia Contains An Additional Mesh Layer
    Defect:
    The passenger airbag deployment door integrated in the instrument panel facia contains an additional mesh layer.
    Remedy:
    Replace the affected instrument panel facia with a part manufactured to the correct specification.

  • Announcement date:
    05/02/2021
    Recalls number:
    R/2021/026
    VIN start:
    SAJDA1AE0MCK69510
    VIN end:
    SAJDA1AE0MCK69510
    Car Build Date:
    21/01/2020 - 21/01/2020
    Concern:
    An Incorrect Front Bumper Reinforcement Panel Has Been Fitted
    Defect:
    An incorrect front bumper reinforcement panel has been fitted at the manufacturing plant.
    Remedy:
    Replace the necessary component with a modified part.

  • Announcement date:
    03/10/2019
    Recalls number:
    R/2019/273
    VIN start:
    SAJDB5BV5KCK58843
    VIN end:
    SAJDA5AV2LCK66551
    Car Build Date:
    04/06/2018 - 09/07/2019
    Concern:
    The Static Noise Level Exceeds The Regulated Maximum Decibel Limit
    Defect:
    Static noise level exceeds the regulated maximum decibel limit.
    Remedy:
    Update the vehicle software to the latest version.

  • Announcement date:
    15/03/2019
    Recalls number:
    R/2019/048
    VIN start:
    SAJDB5BX2KCK55805
    VIN end:
    SAJDB1BXXKCK57925
    Car Build Date:
    09/11/2016 - 05/07/2018
    Concern:
    The Vehicle Failed To Routinely Achieve The Required Levels Of Co2 Emissions
    Defect:
    Vehicles failed to routinely achieve the required levels of CO2 emissions.
    Remedy:
    Update the vehicle software to the latest version.

  • Announcement date:
    29/01/2019
    Recalls number:
    R/2019/014
    VIN start:
    SAJDA1AE6LCK62401
    VIN end:
    SAJDB1BV7KCK62725
    Car Build Date:
    12/10/2018 - 11/12/2018
    Concern:
    The Crankshaft Pulley Retaining Bolt May Fracture
    Defect:
    The crankshaft pulley retaining bolt may fracture due to a production specification error.
    Remedy:
    Replace the crankshaft pulley centre retaining bolt with one that has been manufactured to the correct specification.

  • Announcement date:
    29/03/2018
    Recalls number:
    R/2018/035
    VIN start:
    SAJDB5BX9JCK48252
    VIN end:
    SAJDB5AX6JCK55600
    Car Build Date:
    01/09/2016 - 17/08/2017
    Concern:
    Fuel May Leak
    Defect:
    The brazing of the fuel rail end caps is inconsistent and may not correctly seal the fuel rail ends. Fuel vapour and liquid fuel leaks can occur over time. This can lead to a liquid fuel leak into the engine bay.
    Remedy:
    On affected vehicles replace the fuel rail with a correctly manufactured version.

  • Announcement date:
    23/05/2017
    Recalls number:
    R/2017/170
    VIN start:
    SAJDB5AV7JCK46547
    VIN end:
    SAJD51EE6JCK50387
    Car Build Date:
    16/12/2016 - 24/04/2017
    Concern:
    One Or Both Front Indicators May Fail
    Defect:
    The driver will not be alerted to a failure of one or both of the front directional indicator lamps. This could lead to an extended period of driving with failed lamps where other drivers will not have clear indication of the driver
    Remedy:
    Recall the vehicles that are likely to be affected and update the vehicle with the latest software.

  • Announcement date:
    31/12/2016
    Recalls number:
    R/2017/004
    VIN start:
    SAJWA6AT4H8K41657
    VIN end:
    SAJXJ6DL1HMK46354
    Car Build Date:
    16/02/2016 - 16/12/2016
    Concern:
    Seat Belt Pretensioner May Not Deploy
    Defect:
    It has been identified by the seat belt Pre-Tensioner manufacturer that the pre-tensioner initiator generant mix ratio does not meet specification. This can therefore result in the initiator not functioning correctly which can lead to none activation of the pre-tensioner.
    Remedy:
    Recall all affected vehicles to check the pre-tentioner and if required replace it with a new quality assured component.

  • Announcement date:
    07/11/2016
    Recalls number:
    R/2016/248
    VIN start:
    SAJAJ6946HMK34157
    VIN end:
    SAJAJ6945HMK41956
    Car Build Date:
    12/01/2016 - 15/08/2016
    Concern:
    Vehicle Stability May Be Compromised
    Defect:
    A bolt retaining the rear lower control arm to rear knuckle joint fixing may not have been tightened to correct specification. Failure of the bolt could affect control of the vehicle.
    Remedy:
    On affected vehicles replace the rear lower control arm to rear knuckle joint fixing

  • Announcement date:
    30/06/2016
    Recalls number:
    R/2016/099
    VIN start:
    SAJAC1627CNV38178
    VIN end:
    SAJAC122XDNV43625
    Car Build Date:
    01/06/2012 - 31/10/2012
    Concern:
    Engine May Cut Out
    Defect:
    An incorrectly manufactured crank position sensor may cause the engine to unexpectedly cut out or not to start.
    Remedy:
    On recalled vehicles the engine serial number will be checked and if within the affected range the crank position sensor will be replaced.

  • Announcement date:
    30/06/2016
    Recalls number:
    R/2016/099
    VIN start:
    SAJAC0627CNS53474
    VIN end:
    SAJAA0227DNS67338
    Car Build Date:
    01/06/2012 - 31/10/2012
    Concern:
    Engine May Cut Out
    Defect:
    An incorrectly manufactured crank position sensor may cause the engine to unexpectedly cut out or not to start.
    Remedy:
    On recalled vehicles the engine serial number will be checked and if within the affected range the crank position sensor will be replaced.

  • Announcement date:
    10/09/2015
    Recalls number:
    R/2015/181
    VIN start:
    SAJAC61B1G8K22719
    VIN end:
    SAJAL61X0G8K22402
    Car Build Date:
    09/02/2015 - 24/02/2015
    Concern:
    Loss Of Control
    Defect:
    The electric power steering system may still be set in the factory operating mode. In this condition where another defect arises with the electric power steering system the driver may experience additional unexpected steering inputs from the electric power steering system. These additional system generated steering inputs may exceed the ability of a normal driver who may lose vehicle control with no warning. This can increase the risk of a crash.
    Remedy:
    Recall the vehicles that are likely to be affected to either 1. inspect the electronic power steering software version and where necessary download the correct software or 2. where the vehicle is not accessible to the supplier due to logistical reasons the dealer will replace the steering rack with a steering rack built to the correct specification.

  • Announcement date:
    30/06/2015
    Recalls number:
    R/2015/115
    VIN start:
    SAJWJ6FV8G8K17984
    VIN end:
    SAJXJ6HL1GMK24640
    Car Build Date:
    10/09/2014 - 14/03/2015
    Concern:
    Loss Of Control
    Defect:
    Anti-Roll bars of incorrect specification have been fitted to vehicles equipped with All Wheel Drive (AWD) with Constantly Variable Damping (CVD). In this mis-built condition at the extremes of adhesion and in an over steer situation the Dynamic Stability Control (DSC) system will not mitigate the over steer. The drivers will most likely loose vehicle control of the vehicle. This can increase the risk of a crash.
    Remedy:
    Recall the vehicles that are likely to be affected and replace the rear Anti-roll bar with the correct specification component.

  • Announcement date:
    10/11/2014
    Recalls number:
    R/2014/090
    VIN start:
    SAJAA65B5F8K15254
    VIN end:
    SAJAC61B5F8K15884
    Car Build Date:
    10/06/2014 - 25/06/2014
    Concern:
    Vehicle May Become Unstable At High Speeds
    Defect:
    Due to an issue with the software in the engine management system (EMS) it is possible that the EMS will not restrict the vehicle speed to 137mph if the Deployable Rear Spoiler (DRS) does not deploy when it should . This can affect vehicle stability; although this should not affect vehicles used in the UK due to the National Speed Limit however it could affect vehicles that travel to Europe or are used on private grounds.
    Remedy:
    Recall all affected vehicles to have new software installed.

  • Announcement date:
    27/10/2014
    Recalls number:
    R/2014/145
    VIN start:
    SAJXA6BU8F8K17144
    VIN end:
    SAJWA6AT0F8K18826
    Car Build Date:
    18/08/2014 - 02/10/2014
    Concern:
    Risk Of Fire
    Defect:
    The positive cable fixing to the alternator may come loose and lead to an elevated risk of fire. Additionally there are concerns raised regarding the fixings for the engine mounted belt driven ancillaries. If the fixings fail power assistance to the steering can be lost and more input from the driver will be required to steer the vehicle.
    Remedy:
    Recall the vehicles that are likely to be affected to inspect and torque the front ancillary fixings to the correct specification.
Step 3 - Contact your nearest dealer

Enter your postcode to see your nearest franchised dealer: