Login
My Garage

Peugeot 206 Recalls

There are currently 15 safety recalls out on the Peugeot 206. To find out whether your car is affected, you'll need to find your car's VIN number.

How to find your VIN

The VIN can often be found on the lower-left corner of the dashboard, in front of the steering wheel.

You can read the number by looking through the windshield. The VIN may also appear in a number of other locations:

  • Front of the engine block. This should be easy to spot by opening the bonnet, and looking at the front of the engine.
  • Front of the car frame, near the container that holds windshield washer fluid.
  • Rear wheel well. Try looking up, directly above the tyre.
  • Inside the driver-side doorjamb. Open the door, and look underneath where the side-view mirror would be located if the door was shut.
  • Driver-side doorpost. Open the door, and look near the spot where the door latches, not too far from the seatbelt return.
  • Underneath the spare tyre.
VIN Location Diagram

If you still can't locate the VIN, try consulting your vehicle manual. Or, call a dealership or the manufacturer and request guidance.

Step 2 - See if your car is affected
  • Announcement date:
    13/11/2012
    Recalls number:
    R/2012/135
    VIN start:
    VF3******A8041105
    VIN end:
    VF3******AW080750
    Car Build Date:
    20/05/2010 - 08/07/2010
    Concern:
    Engine May Fail
    Defect:
    It is possible that the con-rod bearing shells will not conform to manufacturer specification. This could lead to premature deterioration of the shells and in time cause the engine to fail.
    Remedy:
    To replace the con-rod bearing shells

  • Announcement date:
    26/11/2008
    Recalls number:
    R/2008/182
    Car Build Date:
    03/07/2008 - 16/07/2008
    Concern:
    Fuel Pipe May Leak
    Defect:
    It has been identified that on subject vehicles a fuel pipe may not be correctly sealed. Should this be the case seepage of fuel may occur.
    Remedy:
    Recalled vehicles will have the subject fuel pipe checked and replaced as necessary.

  • Announcement date:
    27/10/2008
    Recalls number:
    R/2008/155
    Car Build Date:
    01/12/2005 - 31/05/2006
    Concern:
    Windscreen Wipers May Fail
    Defect:
    It has been identified that on subject vehicles the windscreen wiper mechanism has not been manufactured to specification. As a result in time the windscreen wipers could fail.
    Remedy:
    Recalled vehicles will have the windscreen wiper mechanism replaced.

  • Announcement date:
    22/11/2006
    Recalls number:
    R/2006/212
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Front Right Hand Seatbelt Fixing Bolt May Fail
    Defect:
    It has been identified on a small number of vehicles that the spacer for the front right-hand seat belt fixing bolt may have been incorrectly fitted. It is therefore possible that in time this could result in the fixing for the assembly becoming insecure.
    Remedy:
    Recalled vehicles will have the fitting of the spacer checked for compliance with the specification. If found to be necessary the trim will be repositioned and the assembly re-tightened to the correct torque.

  • Announcement date:
    11/04/2005
    Recalls number:
    R/2005/047
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Possible Seepage On The Diesel Fuel Return Pipe
    Defect:
    There is a risk of a manufacturing non conformity on the fuel injection diesel return pipe. This may lead to the possibility of fuel seepage.
    Remedy:
    As a preventive measure likely to be affected vehicles will have the pipe replaced additionally the pipe will be fitted with protective sleeves.

  • Announcement date:
    13/09/2004
    Recalls number:
    R/2004/167
    Car Build Date:
    01/06/2004 - 13/07/2004
    Concern:
    Possibility That The Starter Motor Wiring Loom Is Incorrectly Positioned
    Defect:
    The possibility exists that the starter motor wiring loom has been positioned incorrectly. In consequence there is a risk that this could cause a short circuit.
    Remedy:
    Recall likely to be affected vehicles and correctly fit the wiring loom.

  • Announcement date:
    14/05/2004
    Recalls number:
    R/2004/087
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Possibility Of Erratic Operation Of The Motorized Throttle Body
    Defect:
    The software may cause erratic operation of the motorized throttle which may result in breakage of the throttle stop. This can result in the engine reverting to limp home mode with a possible reduction in braking assistance.
    Remedy:
    Subject vehicles will be recalled and the condition eradicated by carrying out an ECU download.

  • Announcement date:
    07/05/2004
    Recalls number:
    R/2004/082
    Car Build Date:
    28/11/2001 - 02/10/2003
    Concern:
    Possibility That The Rear Spoiler May Detach
    Defect:
    The spoiler mounting on the rear tailgate may in certain cases have some weak points and cause some noise.This may even lead to the loss of the spoiler
    Remedy:
    Recall affected vehicles and replace the 4 spoiler fixing bolts and fit two safety straps

  • Announcement date:
    24/11/2003
    Recalls number:
    R/2003/158
    Car Build Date:
    01/09/1998 - 28/02/2002
    Concern:
    Service Brake Linkage May Become Disconnected
    Defect:
    It is necessary to exchange the two clevis pins on the brake pedal system to avoid any loss of braking. Peugeot have experienced a limited number of incidents where one of the pins has not been locked properly during fitting.
    Remedy:
    Recall the potentially affected vehicles and replace the two clevis pins on the brake pedal system.

  • Announcement date:
    04/05/2002
    Recalls number:
    R/2002/068
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Ignition Key May Foul Steering Column Cowling
    Defect:
    There is a possibility that the steering column cowling may move out of alignment causing the ignition switch to foul on the steering cowling and possibly stick in the start position.
    Remedy:
    Recall affected vehicles and check and where necessary replace the steering column clamp. The cowling unit is replaced on all vehicles recalled.

  • Announcement date:
    28/02/2002
    Recalls number:
    R/2002/006
    VIN start:
    Built out of sequence
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Seat Belt Anchorage Concern.
    Defect:
    There is a risk that the lower attachment on the front and rear left hand seat belts could be loose.
    Remedy:
    Recall the affected vehicles to check and if necessary tighten the seat belt fixings.

  • Announcement date:
    12/11/2001
    Recalls number:
    R/2001/143
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Passenger Airbag May Fail To Deploy
    Defect:
    Incorrect specification passenger airbag internal module.
    Remedy:
    Recall affected vehicles replace airbag.

  • Announcement date:
    15/01/2001
    Recalls number:
    R/2001/008
    VIN start:
    To be advised
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Front Suspension Concern
    Defect:
    There is a possibility that the front stub axle lower ball joint fixing may have been incorrectly machined which may result in separation of the stub axle from the ball joint/lower suspension arm.
    Remedy:
    Recall affected vehicles to check and if required replace the left and right stub axles which will be carried out free of charge.

  • Announcement date:
    19/09/2000
    Recalls number:
    R/2000/096
    VIN start:
    To be advised
    Car Build Date:
    01/01/1970 - 01/01/1970
    Concern:
    Unintentional Deployment Of Side Air Bags
    Defect:
    Possibility of unintentional deployment of either side air bags
    Remedy:
    Recall affected vehicles and replace both side air bag control units.

  • Announcement date:
    18/05/2000
    Recalls number:
    R/2000/099
    VIN start:
    Various
    Car Build Date:
    01/09/1998 - 22/09/1999
    Concern:
    Fuel May Leak From Fuel Filter
    Defect:
    There is a possibility that fuel may seep from fuel filter housing due to external corrosion. A fire risk may exist.
    Remedy:
    Recall affected vehicles and replace aluminium fuel filter with a plastic fuel filter.
Step 3 - Contact your nearest dealer

Enter your postcode to see your nearest franchised dealer: